Windscreen

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Windscreen

Postby paza1 » Sat 29.10.2005, 15:19

Has anyone got any close up digital shots of the windscreen edging seal and A pillar seal area that they could post please :?: I am having problems having my screen replaced :cry:
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester

Postby Dico » Sat 29.10.2005, 15:28

[quote="<br>Image[/quote]
4+ hours stuck in a damp bucket seat with a mad Irishman at the wheel - Deep joy!!!!
User avatar
Dico
Fool Boy Four - Founder
 
Posts: 3569
Joined: Mon 01.12.2003, 09:45
Location: Moderator Manchester

Windscreen

Postby paza1 » Sat 29.10.2005, 16:19

Thanks for the quick response and a nice clear picture, Dico. Do you or anyone else have pics of before and after screen replacement of that area and further down the A pillar :?: I am after a ' what it should look like' piccy if poss.
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester

Re: Windscreen

Postby Dico » Sat 29.10.2005, 16:38

paza1 wrote: Do you or anyone else have pics of before and after screen replacement of that area and further down the A pillar :?: I am after a ' what it should look like' piccy if poss.


Not quite sure where your coming from pazza? Have yours been taken out and disposed off?
Sorry, i dont have any other photos. Infact i pinched that one from the 'door and window' section.
i'd be suprised if there wasnt a pic or two somewhere on this site.
4+ hours stuck in a damp bucket seat with a mad Irishman at the wheel - Deep joy!!!!
User avatar
Dico
Fool Boy Four - Founder
 
Posts: 3569
Joined: Mon 01.12.2003, 09:45
Location: Moderator Manchester

Windscreen

Postby paza1 » Sat 29.10.2005, 18:22

Hi Dico, I am not sure if it has been disposed of yet, good point, will check. However, what has been done so far looks poor to me. I would like to say " this is what it should look like ". I have had a nose around that section and in the gallery but was hoping for some close ups. I will also show them the manual, again :!:
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester

Postby Dico » Sat 29.10.2005, 20:50

Paza

If you've had it replaced on the insurance then th A pillar seals should have been replaced as a matter of course.
Have they fitted new ones or butchered the old ones?
4+ hours stuck in a damp bucket seat with a mad Irishman at the wheel - Deep joy!!!!
User avatar
Dico
Fool Boy Four - Founder
 
Posts: 3569
Joined: Mon 01.12.2003, 09:45
Location: Moderator Manchester

Windscreen

Postby paza1 » Sat 29.10.2005, 21:12

This is an insurance job. They have used the original A post seals BUT they have used a very wide band of sealant down the edge (wonder what's under it) and have not fitted the L shaped corner finishers (wasn't sent to us by Lotus, mate). This is all in spite of me giving them copies of the relevent manual pages and expressing my concerns that it must be done correctly. I was assured that their best people would be on the case, they would take their time and it will be ok because they did a Ferrari last week :!: No points for guessing who the insurance company use for their windscreens. I am speaking with the area manager tomorrow.
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester

Postby TheBard » Sun 30.10.2005, 03:42

Hi Paza,
Goodluck with the screen, Dico borrowed a shot of mine pre-installation of the plastic corner pieces (via PMs in Bromsgrove for less than two quid, so tell your insurer to pull their finger out). Sounds like you need to give the area manager a gentle speaking to.
Ian
Ford Fiesta Mk2, VW Polo, Golf GTi, Lotus Elan, Honda Accord Coupe V6.

Calypso Red Cali #7683 - Bought at 29,000 miles, and sold at 75,000miles.
User avatar
TheBard
Fanatic
 
Posts: 652
Joined: Sun 16.01.2005, 05:22
Location: Washington D.C.

Windscreen

Postby paza1 » Sun 30.10.2005, 13:49

They have agreed to remove the horrible looking band of sealant and redo it. L shaped trim on order. Door weather seals look undamaged and they say they didn't have to remove them. According to the Manual, it does look possible to remove and refit the window finisher without damaging/removing the seal. The saga continues....
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester


Return to Doors and Windows

Who is online

Users browsing this forum: No registered users and 7 guests