Steering Wheel Re-fresh

[peter canepa]

The original wheel is leather but for whatever reason it felt like vinyl. Being a Fed car and by having more than one close call, I want to keep the airbag. Maybe some of you saw my posts on how to remove the airbag,
So I decided to have it re-wrapped and while I'm at it Shift Knob to. The color never matched, and I like a leather shift knob rather than the Ball.
Now if I could just make the horn easier to Honk.

[TorqueHorse]

Stop giving me ideas on how to spend more money!
Looks sharp!
If you still have the original horn buttons, you can swap them out with little micro switches. Someone here recommended these (D2F-FL SWITCH SNAP ACTION SPDT 1A 125V) that friction fit just perfect into the plastic housing.
A teeny bit of Dremel and soldering, but nothing that couldn't be reverted back to original if you wanted.

Also, where did you get those floor mats?

[peter canepa]

Thanks, It was done in your backyard,Texas, Craft Customs, great people. I read the post about the Switch Snap Action, ordered them straight away. Now where are the instruction? I'm handy but I can barely wire a lamp plug.
The matts came from a southern CA shop that is long gone.