Steamy Windows

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Steamy Windows

Postby bobface » Sun 19.08.2007, 15:51

Here's another stupid noob question. Whenever it rains my elan steams up in less than 2 seconds, i put the blowers on the window and the dial to left (all air to front windscreen blowers) and it does sort of clear the screen apart from one triangle shaped section slightly towards the passenger side of the centre, so i basically have this big steam triangle in teh middle which makes it really quite hard to see whats going on.

Does anybody else's do this? could i have a air flow problem? I have the non aircon S2.
bobface
Enthusiast
 
Posts: 105
Joined: Tue 17.04.2007, 14:34
Location: Southampton, England

Postby rip » Sun 19.08.2007, 20:38

Tough question.
I use the other car when it rains. That has a good blower & air con.

I guess a lot of Elaners may do the same

:-D
User avatar
rip
God
 
Posts: 5904
Joined: Sun 08.04.2007, 07:48
Location: Milton Keynes, UK

Postby John_W » Sun 19.08.2007, 22:40

Bobface,

The Elan has good ventilation and I've never had any problems with windows misting up. I drive it in all weathers (not intentionally, it just happens that way).

Are your carpets damp? Thermostat OK?

This has been asked before; see
http://www.lotuselancentral.com/forum/v ... php?t=8520 .

John
User avatar
John_W
Heid-bummer
 
Posts: 3780
Joined: Mon 21.04.2003, 12:31
Location: Aberdeen

Postby DaveT » Mon 20.08.2007, 07:44

8)

I use mine regulary in the rain and the only window I have problem clearing is the plastic rear screen.

D
User avatar
DaveT
Sadly departed but never forgotten
 
Posts: 2183
Joined: Fri 04.11.2005, 17:35
Location: Lincs

Postby lotuska » Mon 20.08.2007, 17:09

Could this be the problem with the foam connector that connects the duct in the clamshell to blower?

From memory mine failed and as its located below the one of the drain holes of the windscreen water started to come out of the blower assembly, but also I kept getting misting up of the windscreen.
User avatar
lotuska
Fanatic
 
Posts: 283
Joined: Wed 23.04.2003, 17:52
Location: Redditch

Postby donsladek » Tue 21.08.2007, 02:47

lotuska wrote:Could this be the problem with the foam connector that connects the duct in the clamshell to blower?

From memory mine failed and as its located below the one of the drain holes of the windscreen water started to come out of the blower assembly, but also I kept getting misting up of the windscreen.


:agree:

Especially if you have no fender liner like my car! It was like pea soup inside until I replaced the foam remnants with some rubber sheet.

Don Sladek
Don Sladek
Calypso Red '91 #37594

If everything seems under control, you're just not going fast enough - Mario Andretti
User avatar
donsladek
Fanatic
 
Posts: 547
Joined: Sun 07.08.2005, 22:19
Location: New Berlin, Wisconsin USA


Return to Interior

Who is online

Users browsing this forum: No registered users and 5 guests