Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
by surfboardfiller » Mon 10.12.2007, 18:26
I am trying to remove the front bumper but it's not coming off.
I un bolted:
The Undertray 4 bolts
Height adjusters behind the wheel arch
4 Main bolts in and under the light pod compartments
but I think there may be more? The service manual says M6 nuts to the radiator but I can't find them. Please help!
Yes can't find my nuts!
before you lot start!
-

surfboardfiller
- God
-
- Posts: 2857
- Joined: Sat 22.10.2005, 14:08
- Location: Somerset - England
by muley » Mon 10.12.2007, 18:36
I think there were some other nuts and bolts holding the lower 'wing' pieces at either end in place. Also, at each end there are some bolts going into a j clip in the bumper (step 2 on page 19 - second sentence). There are no nuts and bolts going to/from the rad or rad support.
Can't think of any others ... Have you got the liners out? If they're off more might be revealed.
Cheers
Jim
LEC Turbo Nutter
1991 Aqua Blue 2006 Ford Focus 2.0 Duratech 2013 Alfa Romeo Giulietta 1.4
-
muley
- Moderator
-
- Posts: 4518
- Joined: Tue 22.04.2003, 09:07
- Location: Wokingham, Berks and Waikanae Beach
by Paul.P » Mon 10.12.2007, 19:12
Phil, i'm pretty sure on SBK's bumper, there was some bolts behind the indicators !
JPS M100 was built from bare chassis up to create one off M100 in the mould of JPS Team Lotus
-
Paul.P
- God
-
- Posts: 4970
- Joined: Sun 14.12.2003, 18:18
- Location: Oakham, Rutland
-
by surfboardfiller » Mon 10.12.2007, 19:32
Thanks Muley, I got the ones next to the undertray. Sheared to pieces.
I'll take out the lights tomorrow and find the other 2. Thanks Paul!

-

surfboardfiller
- God
-
- Posts: 2857
- Joined: Sat 22.10.2005, 14:08
- Location: Somerset - England
by DeeAitch » Mon 10.12.2007, 20:57
Think I've seen a couple lurking under the main light pods when I was looking at the main beam wiring

-

DeeAitch
- God
-
- Posts: 1773
- Joined: Fri 09.05.2003, 22:11
- Location: North East
by muley » Tue 11.12.2007, 10:08
Paul, Phil,
When I removed the bumper I left the lights in and installed the lights before refitting...
I did confuse myself initally by removing 2 clamshell bolts instead of the 2 bumper nuts from under the headlamp pods ...
Cheers
Jim
LEC Turbo Nutter
1991 Aqua Blue 2006 Ford Focus 2.0 Duratech 2013 Alfa Romeo Giulietta 1.4
-
muley
- Moderator
-
- Posts: 4518
- Joined: Tue 22.04.2003, 09:07
- Location: Wokingham, Berks and Waikanae Beach
by surfboardfiller » Wed 12.12.2007, 22:37
I found them! 2 on each side just inside the wheel arch! Got the Clam off too!
Cheers all!

-

surfboardfiller
- God
-
- Posts: 2857
- Joined: Sat 22.10.2005, 14:08
- Location: Somerset - England
Return to Hood/Top, Bodywork and Fittings
Who is online
Users browsing this forum: No registered users and 8 guests