chris.t wrote:... thanks John for your installation instructions which were spot on the bottom mounting plate being the only fiddly bit, oh and one of the leads didn't want to come off the coil post resulting in a small spillage of blood![]()
That'll be the long version of the fitting instructions I PM'd you rather than the precis version above. I didn't say to draw blood.
Glad that you too think there's a definite improvement. Here's hoping it's fixed the problem. I changed the Hall effect sensor on Sunday, but had to catch a plane to London before I could refit it (much fiddling with the new O-ring to get the CAS back on and aligned with the camshaft slot). It'll only take me half an hour when I get back home this weekend to get it refitted and static timing set. Then the misfire MUST have been cured. Surely.
I too would be interested to find out how bad the old coils were. I'll get a multimeter on them sometime, but maybe they'll only fail when under stress.
John

Most likely partial breakdown of the insulation at high voltage so you're unlikely to notice anything unless you've got something like a
Oh, happy days. I remember it as if it were yesterday. Come here little brother and hold these leads for me while I turn the handle........ 
