This was the reply I received today: Answers in red.
I have added some more pictures of the old style cap to the drop box folder listed in the previous post. Hope to have more updates soon.
I have asked for best / strongest way to be used to join the early caps. and if they can fix the splatter & deep insert I would be happy. Colour and shrinkage improvement would be a bonus but I can not guarantee it.... Especially the shrinkage.... To be honest it is barely noticeable. Just thought I would ask
Thank you for the samples. Both John and myself have received them and both share the same concerns.
1. The 2 parts of the Old style cap (that was sent from the US) Look good But we were expecting this to arrive as a 1 piece part the same as the original. I assume that you sent us this part in 2 individual pieces so as we could look at it more closely?
I trust that the production parts will be secured together when we receive them?
As we received these parts un-assembled we are unable to check the parts fit and work correctly.
I will be sending the 1 part that you sent me off to a friend in Europe tomorrow for him to compare it to his parts and to see it it will fit the car.
We see that the samples from US was glued together with two seperate parts, so if you like, we could glue them together before shipment.2. The New style caps seem to have a splatter on the textured surface. This is also visible on the lower surface.
I think this is probably caused by the process used for inserting the brass screw inserts??
The marks on the lower surface are not a problem and I can live with this. But any marks on the upper surface would be un acceptable and would render the part scrap.
Please can you confirm that this will not be on production parts?
Do not worry about splatter, it's not mold problem. because the material was not dried totally, there are some splatter on surface. It's same for other plastic products. For mass production, as only as the material is totally dried, the problem will happen. 3. Looking at the brass screw inserts. 1 of the inserts is too deep and is unusable. This is consistent on all samples. Please could this issue be fixed?
I will check here and get back to you, do you mean the left insert in attached pic is too deep, right?4. I noticed marks on the outer surface where the lugs were installed?? I assume this is the shrinkage that you mentioned earlier? I assume that there is nothing that you can do to rectify this?
Sorry i donnot understand the problem well, could you take some pics to show me the problem? 5.The colour of all parts seem very dark compared to the samples we sent and looking at the parts installed on myy car they look very dark....
Color problem could be resolved, donnot worry.