Rear Screen

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Postby Rambo » Tue 02.08.2005, 23:58

Following my earlier post, here is the result of one application of Renovo. It's hard to photo the differences due to light and flash, but the RHS has been done and the LHS hasn't and I think you can see an improvement in clarity and removal of milkiness after 14 years of oxidation? It won't remove heavy scratches though - just makes it a little less obvious.

Mark
User avatar
Rambo
Don't push me
 
Posts: 9144
Joined: Wed 24.12.2003, 00:37
Location: Both sides of the Tweed

Postby clemo » Thu 04.08.2005, 10:40

ias mentioned earlier..
i removed the hood and frame completely ..
took it into my house , screwed it to a wooden table where i layed inside the roof (on the table) and the needle was thredded through to me and then i passed it back out again...
this required a very strong leather needle, a pair of pliers and some proper thread ...
it took hours !!
and my thub bled a lot. however the end result was perfect.
oh and it was done in the "roof up position" with the new screen tacked in with pins very tightly all the way around first...

have got pictures .. but due to my stupidity do not know how to reduse the piczel size ....

clemo
Jim Clark S2 - 1/12. The one with the Yellow spoke wheels . No 613 on dash (pushed in to factory in wrong order 615 on tub)
User avatar
clemo
LEC Administrator
 
Posts: 5069
Joined: Mon 21.04.2003, 23:24
Location: TORQUAY Devon. Cream first then Jam obviously.

Previous

Return to Hood/Top, Bodywork and Fittings

Who is online

Users browsing this forum: No registered users and 12 guests