My clutch and pressure plate came from Clutch Specialties. Not sure how large an operation, but very helpful guys on the phone who knew exactly the car/transmission I was talking about (Isuzu 78mm is the term I remember).
http://www.clutchspecialties.com/ (though as I just checked their site wans't working - I can get anyone a phone # if you need it).
Having been through 3 combinations of clutch/PP/FW so far, I have found some good and some bad pieces along the way.
First was stock, so you know how that is. My clutch disc gave up after 30,000 miles of regular, stock boost driving and ~5,000 miles of higher boost and track action. I do not launch the car hard (not a drag racer) and I do not know what the car's first 26,000 miles were like, but I'm guessing the 15+ psi shortened the life a fair amount.
Next was the Fidanza FW, a 4 puck custom disc, and a 1400# PP (I believe stock is 1200#). The Fidanza surface and the clutch disc never really mated all that well (the FW needed to be skimmed first), so I can't say how the ultimate grip would have been. It should have been very good. However the car was hard to smoothly start from stoplights. It sometimes shuddered a bit even under careful throttle. Maybe a good setup for drag racing, but definitely not ideal for the street. The extra spring rate in the PP was hardly noticable in the pedal. I consider the stock clutch to be very light and this updgrade was no additional strain on my leg.
I currently have the new FW, an 1800# PP, and a 6 puck Clutch Specialties disc. The FW was skimmed and has never slipped with the disc since install. The 6 puck is much easier to engage smoothly. Not nearly the shudder that the 4 puck had, though every once in a great while it will. The serious PP is noticable at first, but is not something that would hurt your leg even in traffic. The extra pressure and the slightly grippier disc give the engagement a much more sudden feel. A friend of mine called it binary - a fair description. You
would notice a difference from the stock car right away, but after 5-10 minutes of stop-and-go you'd be used to it.
Clutch Specialties estimates this combo will hold 450 HP. For those looking to do moderate bump in HP and wanted additional grip, I figure you could get either a 6 puck disc with stock FW and PP, or do a more serious PP with the stock disc. Either will give you more grip, but the heavier PP/stock disc combo will be the most "streetable" with only a slight increase in pedal effort.
As for the flywheel itself, I'd say the car is slightly easier to drive as a result. I can rev match much easier on downshifts. As for more power to the wheels...I'm guessing there may be a small amount there, but not worth the cost for power gains alone. I never did find out if it helped my HP as it was a mod made with lots of others at the same time. Definitely an upgrade to do only if you are in there doing clutch/PP work.
Rumors of my demise have been greatly exaggerated.
"Track Elan" Monaco White Elan / "Peely" Calypso Red Elan / 2007 Subaru Legacy GT-Cobb Tuned / 1993 Honda CBR600F2