Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
by Don.Hasi » Thu 16.02.2006, 00:50
I ve searched the whole board.
I have to change the rubber urgently on them. But how is the blade taken from the mechanism? For getting it off, one have to get an angle of 90°. But by taking the blades of the windscreen there is a machanic stop by 45°
Cause of the length is no opportunity to get them of
Any solution?
Sorry, for the stupid question
THX in advance
Last edited by
Don.Hasi on Fri 17.02.2006, 00:54, edited 1 time in total.
-
Don.Hasi
- Fanatic
-
- Posts: 530
- Joined: Tue 09.08.2005, 22:30
- Location: Germany, Südpfalz/Elsass
by Sy V » Thu 16.02.2006, 06:22
By far the easiest way is to lift the cover (it's hinged) and undo the mounting nut on the drive spigot.
Talk and song from tongues of lilting grace, sounds caress my ears but not a word I heard could I relay, the story was quite clear - Robert PlantIn Respectful Memory - 21st March 1959 - 14th February 2016
-
Sy V
- LEC Godfather
-
- Posts: 5794
- Joined: Mon 21.04.2003, 07:06
- Location: Lydiate Ash, Bromsgrove, Worcestershire.
by Don.Hasi » Fri 17.02.2006, 00:56
Thx Sy
I ´ll try it like this. Will come back when I´ve made it
-
Don.Hasi
- Fanatic
-
- Posts: 530
- Joined: Tue 09.08.2005, 22:30
- Location: Germany, Südpfalz/Elsass
by nitroman » Sun 19.02.2006, 06:13
I just take a wire-cutter or other device & cut my old one into 2 pieces. That way the old one slides right out.
-
nitroman
- Moderator
-
- Posts: 3554
- Joined: Fri 18.04.2003, 01:17
- Location: Jacksonville, FL
Return to Doors and Windows
Who is online
Users browsing this forum: No registered users and 1 guest
