Is it possible to use parts from a LHD steering rack to refurb a RHD rack? Got a very leaky rack and a spare used rack as a possible replacement, but unsure of its true condition.
Paul
| Home | WikiLEC | Repairs | Upgrades | Gallery | Buy & Sell | Mountain Chips | Meets & Events | Contact |
|
Rack Refurb
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
3 posts
• Page 1 of 1
Rack Refurb
by paul27848 » Sun 18.09.2016, 09:46
- paul27848
- Enthusiast
- Posts: 124
- Joined: Sat 14.05.2011, 09:16
- Location: Hinckley, Leicestershire
Re: Rack Refurb
by kevinrooney » Tue 31.01.2017, 11:56
did you get an answer to this Paul
ive wear in a track rod end (inner ball joint) and thought a track rod end from the LHD rack would suit .
anyone with a spare RHD rack in good condition at a reasonable cost?
Kevin
ive wear in a track rod end (inner ball joint) and thought a track rod end from the LHD rack would suit .
anyone with a spare RHD rack in good condition at a reasonable cost?
Kevin
- kevinrooney
- Newbie
- Posts: 21
- Joined: Mon 28.11.2016, 20:36
- Location: Ireland
Re: Rack Refurb
by Jamie N » Tue 31.01.2017, 12:31
The Tie rods will swap over no issues with that as will the track rod ends, just make sure you are not swapping bad for bad 
.
.-
Jamie N - Seal God
- Posts: 1254
- Joined: Wed 21.12.2005, 18:49
- Location: Sunny Fife.
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests