Spark Advance Readings Query

[muley]

Hi

I ran Elanscan today because my Elan seems a little 'lumpy' on tickover.

I ran Elanscan for a couple of minutes - just on tickover and was surprised at the result - see attached.

Is this normal? If not, any ideas as to what I should look at more closely. Static is 16deg as per spec.

Tks

Jim

[Fredjohn]

Jim
I have to admit I am no expert on Elanscan, but I do know you cannot read your engine/ignition timing with it. You can only do this in diagnostic mode, ie with the paperclip in.

So I guess the answer to your question about the readings: yes it is normal.

Hope I'm right and this helps!!

Fredjohn