replacement Fuel Pump

Leads, coils, plugs, starters, starting probs etc.

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

replacement Fuel Pump

Postby droptop » Sat 22.04.2006, 06:14

I need to replace the fuel pump on my 91 Elan. I can find no listings for this fuel pump from any US suppliers. Does this pump fit any other US car? Hoping to find that it may be the same pump as an Isuzu or something else mass produced.
droptop
Newbie
 
Posts: 16
Joined: Wed 19.04.2006, 21:31
Location: Tampa,FL

Postby Sy V » Sat 22.04.2006, 07:14

You have tried re-setting the inertia swith in the battery compartment haven't you?
Image

Talk and song from tongues of lilting grace, sounds caress my ears but not a word I heard could I relay, the story was quite clear - Robert Plant

In Respectful Memory - 21st March 1959 - 14th February 2016
User avatar
Sy V
LEC Godfather
 
Posts: 5794
Joined: Mon 21.04.2003, 07:06
Location: Lydiate Ash, Bromsgrove, Worcestershire.

Postby droptop » Sat 22.04.2006, 13:08

What is the easiest way to reset the switch?

Simply pushing the button on top?
droptop
Newbie
 
Posts: 16
Joined: Wed 19.04.2006, 21:31
Location: Tampa,FL

Re: replacement Fuel Pump

Postby Doc Fizzix » Sat 22.04.2006, 15:52

droptop wrote:I need to replace the fuel pump on my 91 Elan. I can find no listings for this fuel pump from any US suppliers. Does this pump fit any other US car? Hoping to find that it may be the same pump as an Isuzu or something else mass produced.


Having been down the road before only to find that my problem was not the fuel pump I find it very had to imagine the fuel pump going bad. I did replace mine but the problem ended up being the injectors. I am not sure what problems you are having but you should check your fuel pressure or things will get very expansive if you just start replacing things, that was what I did :cry:
User avatar
Doc Fizzix
God
 
Posts: 2281
Joined: Thu 23.09.2004, 23:36
Location: Deep in the heart of Texas

Postby droptop » Sun 23.04.2006, 00:40

Thanks for the help so far. After 1st establishing that the inertia switch was reset and good via pushing the plunger in and pulling it back out...
I moved on to make sure the fuel pump had power and that the relay was good. I need to test the pressure and spent half the day looking for my fuel pressure test kit. Unfortunately it was not to be found before other committments took over for the weekend. I can make the car run by spraying fuel into the intake plenum.
Bear in mind that this car has 216,000 miles showing on the odometer!!!

Perhaps I can go for the highest mileage record for a 1991 Elan.:-)
droptop
Newbie
 
Posts: 16
Joined: Wed 19.04.2006, 21:31
Location: Tampa,FL

Postby droptop » Sun 30.04.2006, 13:01

Where can I find the special tool used to separate the fuel lines from the pump?
droptop
Newbie
 
Posts: 16
Joined: Wed 19.04.2006, 21:31
Location: Tampa,FL

Postby Doug » Mon 01.05.2006, 08:12

there's a fuel pump FUSE next to the inertia switch so be sure that is okay as well!
Image
User avatar
Doug
LEC Founder
 
Posts: 7468
Joined: Thu 17.04.2003, 06:43
Location: Oregon Coast, USA


Return to Ignition and fuelling

Who is online

Users browsing this forum: No registered users and 6 guests