...waits for obvious knob jokes.....
I was wondering of anybody had measured the thread on the knob end of the gear stick?
| Home | WikiLEC | Repairs | Upgrades | Gallery | Buy & Sell | Mountain Chips | Meets & Events | Contact |
|
Gear Knob Thread
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
2 posts
• Page 1 of 1
Gear Knob Thread
by CallMeLegend » Thu 28.05.2020, 11:34
- CallMeLegend
- Fanatic
- Posts: 328
- Joined: Tue 26.05.2020, 08:42
- Location: Bristol
Re: Gear Knob Thread
by Rocklobster » Tue 02.06.2020, 09:44
Any self respecting elan owner has measured his knob end. M10 x 1.25.
There you are. A cheap knob gag and your answer, both in the same paragraph.
There you are. A cheap knob gag and your answer, both in the same paragraph.
Pete
Success is the ability to go from one failure to another with no loss of enthusiasm.
Success is the ability to go from one failure to another with no loss of enthusiasm.
-
Rocklobster - Tinkerer
- Posts: 91
- Joined: Tue 09.01.2018, 22:25
- Location: Lincoln UK
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests