Lotus Elan Central

Everything M100

Skip to content

Gear Knob

Drivetrain problems

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Post a reply

Gear Knob

Postby Silver Shadow » Tue 13.05.2008, 16:36

I want to change the gear knob since it is very worn out. Can someone please point me out how to do it? Is it by unskrewing? I've tried but I didn't want to force it too much... Thanks
Silver Shadow
Newbie
 
Posts: 32
Joined: Sun 23.03.2008, 18:10
Location: Portugal
Top

Postby F1 LOTUS » Tue 13.05.2008, 16:47

There is a tiny (3mm?) hex screw at the front of the knob that must be unscrewed before you can unscrew the knob.
User avatar
F1 LOTUS
God
 
Posts: 2199
Joined: Thu 17.04.2003, 18:17
Location: SoCal, USA
Top

Postby theelanman » Thu 15.05.2008, 21:29

could you do me a favour?
when you have the original knob off....can you measure the diameter of the gear lever itself.....the size and pitch of the thread and also the length of the thread......on the gear stick bit... :)
cheers
G
I’m normally not a praying man, but if you’re up there, please save me, Superman.
User avatar
theelanman
Moderator
 
Posts: 7296
Joined: Fri 30.04.2004, 15:52
Location: peak district
Top

Postby Silver Shadow » Fri 16.05.2008, 12:05

No problem. I haven't done it yet but as soon as I do it I will tell you
Silver Shadow
Newbie
 
Posts: 32
Joined: Sun 23.03.2008, 18:10
Location: Portugal
Top

Postby DeeAitch » Fri 16.05.2008, 13:08

IIRC the thread is M10x1.25p. Lever Dia is bigger - probably Dia 12mm but easy to check as the boot just slides down it - I'll nip out and have a look :wink:
Checked and it is 13mm Dia
User avatar
DeeAitch
God
 
Posts: 1773
Joined: Fri 09.05.2003, 22:11
Location: North East
Top
Post a reply

Return to Transmission, and Clutch

Who is online

Users browsing this forum: No registered users and 3 guests

© 1998 – 2026 Lotus Elan Central. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group