Impact driver for crankshaft pulley bolt

Discuss items to help maintain, repair, beautify, or use on your beloved Elan here

Moderators: theelanman, dapinky, Nige, Elanlover, Sy V, muley, Enright, algirdas, nitroman, GeoffSmith, clemo, Dave Eds, Specky, DaveT

Impact driver for crankshaft pulley bolt

Postby KenS » Wed 04.10.2017, 21:54

If anyone is considering a diy cam belt change and worried about the crankshaft pulley bolt - I can recommend the DeWalt DCF899HN impact driver. Started my belt change last weekend and it had no trouble at all in removing the bolt - making it the easiest part of the job by far! Its quite a heavy tool, but good spec - 3 setting 135/400/950Nm which seems a lot higher than others. I have changed the water pump (had to file off one edge to fit), tensioner and idler pulley, just got to finish getting the cam covers, other belts and engine mount back on and get to those pesky alternator bolts.
Last edited by KenS on Thu 05.10.2017, 18:18, edited 1 time in total.
S2 M100 NMY #285
N/A 2010 Evora
User avatar
Posts: 97
Joined: Mon 27.10.2014, 21:04
Location: North Kent Coast

Re: Impact driver for crankshaft pulley bolt

Postby HJ2 » Thu 05.10.2017, 10:02

Almost there! :burnout:
If you always do what you always did, you always get what you always got
User avatar
Wodan - God of the Low Lands
Posts: 4135
Joined: Fri 06.06.2008, 10:54
Location: Delft, the Netherlands

Return to Tools

Who is online

Users browsing this forum: No registered users and 1 guest