| Home | WikiLEC | Repairs | Upgrades | Gallery | Buy & Sell | Mountain Chips | Meets & Events | Contact |
|
Can anyone help?
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
6 posts
• Page 1 of 1
Can anyone help?
by Jayeme69 » Fri 19.08.2022, 13:16
On my recently acquired basket case , i can only get it to run by supplying power directly to the fuel pump, i have power and an earth at the relay but dont know what i should be looking for at pin No 1 ? anyone?
You do not have the required permissions to view the files attached to this post.
-
Jayeme69 - Newbie
- Posts: 41
- Joined: Thu 18.08.2022, 09:07
- Location: Scunthorpe
Re: Can anyone help?
by par » Fri 19.08.2022, 13:42
Could be the fuel cut off switch has tripped when being stored and moved.
I believe it is on the passenger side of the rear hood stowage compartment under the carpet.
I believe it is on the passenger side of the rear hood stowage compartment under the carpet.
-
par - Fanatic
- Posts: 572
- Joined: Thu 19.02.2015, 23:22
- Location: Fife
Re: Can anyone help?
by par » Fri 19.08.2022, 13:44
Think it is labelled as the Inertia Switch in that diagram.
-
par - Fanatic
- Posts: 572
- Joined: Thu 19.02.2015, 23:22
- Location: Fife
Re: Can anyone help?
by Jayeme69 » Fri 19.08.2022, 17:52
par wrote:Think it is labelled as the Inertia Switch in that diagram.
Inertia switch is working fine, no power to the Relay when its up and power to Relay when its down.
-
Jayeme69 - Newbie
- Posts: 41
- Joined: Thu 18.08.2022, 09:07
- Location: Scunthorpe
Re: Can anyone help?
by Blaster » Sun 21.08.2022, 15:46
Jayeme69 wrote:par wrote:Think it is labelled as the Inertia Switch in that diagram.
Inertia switch is working fine, no power to the Relay when its up and power to Relay when its down.
Has someone installed an immobiliser or a secret switch to cut the power to the pump.
Tony
1990 Lotus Elan SE 2009 Triumph Daytona 675SE
2012 KTM Freeride 350 2008 VW T5 4-Motion camper.
1995 Defender 300TDi 2012 Ducati Hypermotard
2018 AC Nitro 200 and Dudek Solo wing
1990 Lotus Elan SE 2009 Triumph Daytona 675SE
2012 KTM Freeride 350 2008 VW T5 4-Motion camper.
1995 Defender 300TDi 2012 Ducati Hypermotard
2018 AC Nitro 200 and Dudek Solo wing
-
Blaster - Enthusiast
- Posts: 159
- Joined: Tue 18.08.2020, 22:29
- Location: Hertford
Re: Can anyone help?
by Tuga2112 » Mon 22.08.2022, 08:00
follow the wires.
you will learn to take apart the interior trim piece of the hood stowage compartment, centre console, then the seats (to look under the dash confortably) .
id stop taking things apart when it comes to the dashboard, because its a lot of work, but all other parts are easy to take out and put back in
with the seats out you should be able to see wiring behind the dash without much trouble and find out what has gone wrong with the wiring.
you will learn to take apart the interior trim piece of the hood stowage compartment, centre console, then the seats (to look under the dash confortably) .
id stop taking things apart when it comes to the dashboard, because its a lot of work, but all other parts are easy to take out and put back in
with the seats out you should be able to see wiring behind the dash without much trouble and find out what has gone wrong with the wiring.
Still learning
Youtube Channel @Tuga2112 M100 repair videos
Youtube Channel @Tuga2112 M100 repair videos
-
Tuga2112 - God
- Posts: 3039
- Joined: Fri 12.09.2014, 22:54
- Location: Durham with a regular trip to Walsall
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests