| Home | WikiLEC | Repairs | Upgrades | Gallery | Buy & Sell | Mountain Chips | Meets & Events | Contact |
|
should I change the head bolts?
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
4 posts
• Page 1 of 1
should I change the head bolts?
by 22rabbits » Mon 14.11.2016, 16:00
Hi guys, my mechanic asked me to consider getting head bolts for when he's doing the head gasket. he said it might run the risk of breaking on re-tightening but he's leaving it to me to make the call. What do you guys think? and are they going to be easily got in the local motorfactors?
- 22rabbits
- Newbie
- Posts: 14
- Joined: Mon 07.11.2016, 16:12
Re: should I change the head bolts?
by theelanman » Mon 14.11.2016, 16:44
they'll only break if he over tightens them.......and even then it'll take a lot of over tightening.......
you will need to retorque them after every run for the first few runs while the heat and the bolts bed back in......
you will need to retorque them after every run for the first few runs while the heat and the bolts bed back in......
I’m normally not a praying man, but if you’re up there, please save me, Superman.
-
theelanman - Moderator
- Posts: 7296
- Joined: Fri 30.04.2004, 15:52
- Location: peak district
Re: should I change the head bolts?
by dapinky » Mon 14.11.2016, 19:09
As above - they are NOT 'stretch' bolts on the elan, and can safely be re-used.
Dave
Just the one now, but this one's mine! - and it will be finished eventually..... - but also temporary custodian of a project until it is finished enough for Angie to drive it
...oh, and a 2006 Freelander destined for the jungles of The Gambia - 4500 miles across roads, desert and tracks - what could possibly go wrong?
Just the one now, but this one's mine! - and it will be finished eventually..... - but also temporary custodian of a project until it is finished enough for Angie to drive it
...oh, and a 2006 Freelander destined for the jungles of The Gambia - 4500 miles across roads, desert and tracks - what could possibly go wrong?
-
dapinky - LEC Administrator
- Posts: 10605
- Joined: Sun 15.10.2006, 12:54
- Location: As far west as you can get in West Wales before you become Irish (Pembroke Dock).
Re: should I change the head bolts?
by 22rabbits » Mon 14.11.2016, 21:14
thanks guys. not something i need to know anymore unfortunately 
Check out my new thread any ideas would be greatly appreciated
viewforum.php?f=37
Check out my new thread any ideas would be greatly appreciated
viewforum.php?f=37
- 22rabbits
- Newbie
- Posts: 14
- Joined: Mon 07.11.2016, 16:12
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests