When I first picked up my project it started and ran but would not drive under load. It would miss and back fire etc.
On checking the timing it was at around 1 ° advance.
So following the procedure to adjust I've got it to 16° just but the CAS is on its max adjustment.
The car now runs a dream. Pulls like a train starts first flick of the key but it cant be right to have it that far adjusted.
Best guess is the belt is a tooth out on one cam but it runs so well I'm reluctant to mess with it.
| Home | WikiLEC | Repairs | Upgrades | Gallery | Buy & Sell | Mountain Chips | Meets & Events | Contact |
|
Max timing adjustment
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
3 posts
• Page 1 of 1
Max timing adjustment
by Hoppo » Thu 11.04.2019, 20:44
- Hoppo
- Newbie
- Posts: 24
- Joined: Thu 28.02.2019, 19:05
- Location: Leicestershire
Re: Max timing adjustment
by Simon_P » Thu 11.04.2019, 21:39
1 degree error wouldn't be detectable.
Just checking that you did it in service mode?
Full adjustment would be more than one tooth out.
Just checking that you did it in service mode?
Full adjustment would be more than one tooth out.
- Simon_P
- God
- Posts: 2602
- Joined: Fri 06.08.2004, 12:33
- Location: Kent UK
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests