Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
by nissias » Wed 09.05.2007, 15:11
i can get some yeah. give me up to tomorrow! btw these wheels fit exactly on the hub beneath without the need of spacer or anything else. This does not allow me to enter the lotus caps on the center of the wheels. Does anyone have a clue if I can put something on top? I found a guy that does various kinds of things with aluminium and he told me he can do something on the wheel cap at the end of the axle. I have noticed that there are caps on the rear wheels but none on the front. These things are those small round caps that are full of grease inside and clip on top of the end of the axle. If anyone knows where I can find a pair for the front then I can do something for my Lotus caps

Last edited by
nissias on Wed 09.05.2007, 15:41, edited 1 time in total.
M100 (91) Turbo - Pacific Blue
-

nissias
- Fanatic
-
- Posts: 481
- Joined: Tue 09.08.2005, 17:33
- Location: CYPRUS, EU
-
by nissias » Wed 09.05.2007, 15:27
Doug wrote:do you have any pics of your Elan with these wheels yet!
I was just looking at this exact wheel in gunmetal to get for my Evo
(assuming I can remove that blue crap from the wheel)
the blue stickers come with the wheel but they are not sticked on. so no worries on that. the work emotion fits on lots of evo's from factory. the work emotion cr is deeper kind of rim and it's a bit different. you also get the blue valves

M100 (91) Turbo - Pacific Blue
-

nissias
- Fanatic
-
- Posts: 481
- Joined: Tue 09.08.2005, 17:33
- Location: CYPRUS, EU
-
by nissias » Wed 16.05.2007, 00:04
the center lotus caps are yet to be fitted. i just have to think how.

M100 (91) Turbo - Pacific Blue
-

nissias
- Fanatic
-
- Posts: 481
- Joined: Tue 09.08.2005, 17:33
- Location: CYPRUS, EU
-
by theelanman » Wed 16.05.2007, 00:50
wot were the offsets on these agian?????

I’m normally not a praying man, but if you’re up there, please save me, Superman.
-

theelanman
- Moderator
-
- Posts: 7296
- Joined: Fri 30.04.2004, 15:52
- Location: peak district
-
by nissias » Wed 16.05.2007, 08:50
i think +47 and they fit perfectly on the car. no spacers needed or anything else

M100 (91) Turbo - Pacific Blue
-

nissias
- Fanatic
-
- Posts: 481
- Joined: Tue 09.08.2005, 17:33
- Location: CYPRUS, EU
-
by donsladek » Fri 18.05.2007, 02:41
I found this site for comparing wheel and tire combinations - only problem is they only go to +55 offset
www.rims-n-tires.com
Don Sladek
Don Sladek
Calypso Red '91 #37594
If everything seems under control, you're just not going fast enough - Mario Andretti
-

donsladek
- Fanatic
-
- Posts: 547
- Joined: Sun 07.08.2005, 22:19
- Location: New Berlin, Wisconsin USA
by Elanlover » Fri 18.05.2007, 13:27
Well, if you could actually BUY wheels there with a +55 offset that'd be pretty darn good!
I do whatever my Rice Crispies tell me to do
-

Elanlover
- Moderator
-
- Posts: 3513
- Joined: Fri 05.08.2005, 19:11
- Location: The Great White North
by Dave M » Fri 18.05.2007, 17:02
Those wheels look familiar, nissias.

Here are the Racing Dynamic wheels I finally received and installed...
You do not have the required permissions to view the files attached to this post.
Rumors of my demise have been greatly exaggerated.
"Track Elan" Monaco White Elan / "Peely" Calypso Red Elan / 2007 Subaru Legacy GT-Cobb Tuned / 1993 Honda CBR600F2
-

Dave M
- God
-
- Posts: 937
- Joined: Mon 18.07.2005, 01:40
- Location: Ada, MI
by nissias » Sat 19.05.2007, 01:39
Dave M wrote:Those wheels look familiar, nissias.

Here are the Racing Dynamic wheels I finally received and installed...
nice wheels dave!
i am still looking for what to do with the center caps though. i bet ur car would look much better with the lotus center caps too

M100 (91) Turbo - Pacific Blue
-

nissias
- Fanatic
-
- Posts: 481
- Joined: Tue 09.08.2005, 17:33
- Location: CYPRUS, EU
-
Return to Wheels and Tyres
Who is online
Users browsing this forum: No registered users and 4 guests