Alternator, waterpump, A/C, sensors, CAS, etc.
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
by mlewi6 » Mon 18.02.2008, 20:03
I am the new and proud owner of a 65,000mile '91 Elan. Second outing, the accelerator pedal was stuck, and after pushing down on it, gave way. I am assuming that I have a cable problem of some kind. I checked at the other end of the cable, it was attached but loose. My question is, how the heck do I get to the place where the cable must connect to the pedal. Many thanks,
-
mlewi6
- Newbie
-
- Posts: 14
- Joined: Mon 14.01.2008, 06:14
- Location: Santa Rosa, California
by rip » Mon 18.02.2008, 20:24
Not sure, but cables usually route to the correct location in the bulkhead to just poke through & loop over the top of the cable.
Welcome to the forum. I hope (& expect) you get a proper answer quite soon.
Get yourself to Donington if possible. The convoy should be something special.
If you put a location in your profile, you may get an offer of help with your cable.

1990 SE
-

rip
- God
-
- Posts: 5904
- Joined: Sun 08.04.2007, 07:48
- Location: Milton Keynes, UK
Return to Engine Ancillaries
Who is online
Users browsing this forum: No registered users and 1 guest