Alternator, waterpump, A/C, sensors, CAS, etc.
Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith
by dermotbell » Thu 31.07.2008, 15:12
I arrived back in UK after 12 days away and had an uneventful journey home until i stopped at a gate.
It was 2am and I was pretty tired so didn't notice the temp gauge on the 25 min drive home. What i did notice was the fans were going, which was unusual as the drive home is open roads. The temp gauge was nearing 3/4.
My first thought is that it was the thermostat seized in the shut position but why then were the fans on. Surely if the thermostat was seized no water would get to the sensor as it is on the other side of the circuit.
When I stopped (eng off) the fans kept going and after 2-3 mins cooled the temp. Is it possible the thermostat opened at a higher temp to allow the water to circulate.
I am planning to replace the thermostat, and am now searching the site for alternatives to OEM.
Dermot Bell
-

dermotbell
- Fanatic
-
- Posts: 487
- Joined: Sun 11.06.2006, 21:04
- Location: Dubai
by RayD » Thu 31.07.2008, 15:27
Hi Dermot,
Thermostats rarely fail closed, and if it did there'd be enough temperature to trigger the switch, after a while. There’s usually a bleed hole in the stat allowing water through even when it’s shut.
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by GeoffSmith » Thu 31.07.2008, 15:34
If you haven't been topped up with antifreeze/
corrosion inhibitor it could be grunged up and sticking. They do have a bleed hole but that would delay the response of the fans and obviously wouldn't provide full cooling. Look no further than the
Wiki for replacements. Watch out for HGF.
Calypso Red S2 #417
USB ElanScan interfaces - £60 incl. UK P&P & £65 incl. ROW P&P
-

GeoffSmith
- Kitty Fiddler
-
- Posts: 15628
- Joined: Fri 03.02.2006, 21:57
- Location: S2#417 in Tytherington, Gloucestershire
-
by dermotbell » Thu 31.07.2008, 15:39
RayD wrote:Hi Dermot,
Thermostats rarely fail closed, and if it did there'd be enough temperature to trigger the switch, after a while. There’s usually a bleed hole in the stat allowing water through even when it’s shut.
Ray
I thought (and previous exp on fiestas) they always failed closed?
Geoff, yeah I keep a regular eye on the anti-freeze. Already done HGF 2 years ago, don't want another. Checked her this morning and the header tank is empty, not sure if this is a result of overheat, or if it has a leak. Was fine just before I went overseas. Am I right in saying that the Halfords version has no relief hole? I'm sure I read it somewhere.
Dermot Bell
-

dermotbell
- Fanatic
-
- Posts: 487
- Joined: Sun 11.06.2006, 21:04
- Location: Dubai
by L.G. » Thu 31.07.2008, 18:06
Did you ever change the water pump? I had a corrosion problem as Geoff described and as a result my water pump was in an unbelivable condition. Worth looking at if the car doesn't come back to normal.
L.G.
Edit: Grammar check

'95 S2 driver #286
-

L.G.
- Fanatic
-
- Posts: 319
- Joined: Wed 07.09.2005, 22:34
- Location: Istanbul/Turkey
by RayD » Thu 31.07.2008, 20:17
dermotbell wrote:
I thought (and previous exp on fiestas) they always failed closed?
Fair enough Dermot, if you have had them fail closed I’m sure you’re right.
There are also plenty of instances on the Internet of people saying the same.
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by muley » Thu 31.07.2008, 20:43
Hi,
I did have one fail closed (on the Blue Elan) a while ago.
It overheated

- the fans were on while I was going along!
Jim
LEC Turbo Nutter
1991 Aqua Blue 2006 Ford Focus 2.0 Duratech 2013 Alfa Romeo Giulietta 1.4
-
muley
- Moderator
-
- Posts: 4518
- Joined: Tue 22.04.2003, 09:07
- Location: Wokingham, Berks and Waikanae Beach
by RayD » Thu 31.07.2008, 21:03
Unfortunately the fans won’t be much help with a closed thermostat
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by muley » Thu 31.07.2008, 21:40
RayD wrote:Unfortunately the fans won’t be much help with a closed thermostat
Ray
I think they helped a bit...as there was
some flow through the 'stat...
... better than nothing anyway.
Jim
LEC Turbo Nutter
1991 Aqua Blue 2006 Ford Focus 2.0 Duratech 2013 Alfa Romeo Giulietta 1.4
-
muley
- Moderator
-
- Posts: 4518
- Joined: Tue 22.04.2003, 09:07
- Location: Wokingham, Berks and Waikanae Beach
by rip » Thu 31.07.2008, 22:05
dermotbell wrote:
I thought (and previous exp on fiestas) they always failed closed?
I have had one failed stat:- It failed open. I thought that was normal, but it makes sense that closed failures would be more common because they would be in this state when parked up with cold coolant.
1990 SE
-

rip
- God
-
- Posts: 5904
- Joined: Sun 08.04.2007, 07:48
- Location: Milton Keynes, UK
by Sy V » Fri 01.08.2008, 05:47
Are you sure it was the fans running after switch off, and not the recirc water pump?
Talk and song from tongues of lilting grace, sounds caress my ears but not a word I heard could I relay, the story was quite clear - Robert PlantIn Respectful Memory - 21st March 1959 - 14th February 2016
-

Sy V
- LEC Godfather
-
- Posts: 5794
- Joined: Mon 21.04.2003, 07:06
- Location: Lydiate Ash, Bromsgrove, Worcestershire.
by dermotbell » Fri 01.08.2008, 13:18
Ray, wasn't trying to suggest that you were wrong, merely my experience was the opposite. I have been wrong on enough occasions to welcome all advice and experiences.
Having got over my jet lag I investigated the issue, basically as the header tank was empty I turned the heater to hot and filled her up several time with engine running, no air in the radiator bleed screw. Seems to work perfectly now.
As she was fine before I went away, I can only assume a slow leak somewhere, can't see anything obvious but I guess the radiator is most obvious suspect.
Dermot Bell
-

dermotbell
- Fanatic
-
- Posts: 487
- Joined: Sun 11.06.2006, 21:04
- Location: Dubai
by RayD » Sun 03.08.2008, 18:33
Me thinking the thermostat won’t fail closed has an element of wishful thinking and a bit of optimism attached to it.
The number of people saying they only fail closed are so widespread it must be true. While some may have been mistaken by finding the stat closed when they came to remove it, the ones who tested it and found it wouldn’t open have to be right.
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by rip » Sun 03.08.2008, 21:21
RayD wrote:The number of people saying they only fail closed are so widespread it must be true.
No way.
My stat failed open. No doubts about that because the engine would not get up to temperature.
The majority may fail closed, but definitely not all.
1990 SE
-

rip
- God
-
- Posts: 5904
- Joined: Sun 08.04.2007, 07:48
- Location: Milton Keynes, UK
by RayD » Sun 03.08.2008, 21:53
RayD wrote:Thermostats rarely fail closed...
RayD wrote:
The number of people saying they only fail closed are so widespread it must be true. While some may have been mistaken by finding the stat closed when they came to remove it, the ones who tested it and found it wouldn’t open have to be right.
I agree with you RIP
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by muley » Mon 04.08.2008, 09:44
I think the majority fail open (luckily!)
I've had 2 fail open and 1 closed
Jim
LEC Turbo Nutter
1991 Aqua Blue 2006 Ford Focus 2.0 Duratech 2013 Alfa Romeo Giulietta 1.4
-
muley
- Moderator
-
- Posts: 4518
- Joined: Tue 22.04.2003, 09:07
- Location: Wokingham, Berks and Waikanae Beach
by dermotbell » Mon 04.08.2008, 23:23
Well I guess it's a bit of both then.
Dermot Bell
-

dermotbell
- Fanatic
-
- Posts: 487
- Joined: Sun 11.06.2006, 21:04
- Location: Dubai
by Specky » Tue 05.08.2008, 00:48
The other month I put a new thermostat in on Spec...
and guess what the new ones just failed open... the engines sounds like a bubbling geezer after shut down...
I must fit my old one ASAP...
TTFN
If you have a problem, if no one else can help, and if you can find them, maybe you can hire... The N/A-Team.
-

Specky
- Moderator
-
- Posts: 5982
- Joined: Sun 07.09.2003, 23:19
- Location: Swindon
by RayD » Tue 05.08.2008, 11:14
Good idea Dave,
There’s probably more to be said for cleaning the old one up every so often than putting a new one in that might be a lesser quality.
Ray
-

RayD
- Forum Member
-
- Posts: 2142
- Joined: Mon 20.03.2006, 19:45
- Location: South Yorkshire
by Specky » Tue 05.08.2008, 11:51
RayD wrote:Good idea Dave,
There’s probably more to be said for cleaning the old one up every so often than putting a new one in that might be a lesser quality.
Ray
The new one was a Hal-Frauds...
TTFN
If you have a problem, if no one else can help, and if you can find them, maybe you can hire... The N/A-Team.
-

Specky
- Moderator
-
- Posts: 5982
- Joined: Sun 07.09.2003, 23:19
- Location: Swindon
Return to Engine Ancillaries
Who is online
Users browsing this forum: No registered users and 5 guests