Bonnet badge replacement

[r19]

Some moron has tried to get my bonnet badge off with a screwdriver and bent it and broken the enamel.The car is a series 2.The underside of the bonnet has two black rubber cylinders attached to the badge.I am struggling to get these off and when i do will the badge release also are these rubbers available to fit a new badge

[nitroman]

Sounds to me like someone placed the protective rubber cylinders back on the two threaded posts to hold your badge on! All 3 M100s I've owned had nuts threaded onto these posts holding the badge on.

[M100 TWO]

sounds like someone has used rawle nuts use a pair of point nose pliers and unscrew the whole rubber tube there is a nut bonded inside the rubber
diff

[r19]

Thank you M100 TWO.They were as you described and the badge is now removed.I have just bought my series two and am in Poole so may see you around.

[M100 TWO]

glad it worked out OK do not buy the heritage badge it has the wrong PCD
diff

[Ade]

Hi,

When I replaced my badge, I put 2 rubber washers between the body, and the nuts, tighten against the rubber, to hold the badge tight without pulling it into the paint.


Ade