Washer tank empty indicator

Post cries for help here if your topic fits no other thread in this category.

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Washer tank empty indicator

Postby timmo » Thu 17.08.2023, 11:29

Hello fellow LEC'ers
Has anybody get any idea why my washer fluid tank indicator is showing that the washer fluid tank is empty when in reality I can't actually fit another millilitre of fluid into the b*****. Clearly I've got a problem with the indicator any suggestions?
I wonder how much deeper the ocean would be without sponges.
User avatar
timmo
God
 
Posts: 1109
Joined: Sat 21.02.2004, 09:57
Location: Windsor

Re: Washer tank empty indicator

Postby Tuga2112 » Sun 20.08.2023, 22:46

timmo wrote:Hello fellow LEC'ers
Has anybody get any idea why my washer fluid tank indicator is showing that the washer fluid tank is empty when in reality I can't actually fit another millilitre of fluid into the b*****. Clearly I've got a problem with the indicator any suggestions?


sounds like an issue with the switch/sensor at the end of the tank. i have the same issue in the NA but havent bothered to look into it yet.
i am pretty sure i've seen the issue mentioned before and i suspect its a fairly common one to come across. dont recall ever reading about a solution however, this is a vague recolection from the days when i just bought my car. and since i didnt have the issue i wasnt going to read in detail about the problem
Still learning
Youtube Channel @Tuga2112 M100 repair videos
User avatar
Tuga2112
God
 
Posts: 3039
Joined: Fri 12.09.2014, 22:54
Location: Durham with a regular trip to Walsall

Re: Washer tank empty indicator

Postby Saltire » Mon 21.08.2023, 07:34

I can’t help directly, because it’s not a problem I’ve experienced on the Lotus. I have had it on another car, and the issue was that the level indicator was driven from a float (like the ball cock in your cold water tank). Don’t ask me how, but the float had sprung a leak along its seam, and was full of liquid, so it always showed empty.

I’ve never had the Lotus tank to bits, so I don’t know how the warning light is driven, but, if it were me, I’d siphon the contents out of the tank, remove it from the car, and find that float or equivalent!
Jonathan

1995 Elan S2, BRG - Now sadly sold
Mrs Saltire’s 2021 Mini Countryman Cooper S
Mrs Saltire’s 2022 BMW i3S
User avatar
Saltire
God
 
Posts: 2457
Joined: Sun 05.04.2015, 22:27
Location: Left foot in Wiltshire, right foot in Gloucestershire, heart in Scotland

Re: Washer tank empty indicator

Postby dapinky » Mon 21.08.2023, 09:19

I haveno idea, but I'd just like to say, on behalf of those of us who are still not Politically Correct.....

..... it's good to see you posting again Timmo ;-)
Dave

Just the one now, but this one's mine! - and it will be finished eventually..... - but also temporary custodian of a project until it is finished enough for Angie to drive it


...oh, and a 2006 Freelander destined for the jungles of The Gambia - 4500 miles across roads, desert and tracks - what could possibly go wrong?
User avatar
dapinky
LEC Administrator
 
Posts: 10605
Joined: Sun 15.10.2006, 12:54
Location: As far west as you can get in West Wales before you become Irish (Pembroke Dock).

Re: Washer tank empty indicator

Postby KenS » Mon 21.08.2023, 10:47

Having nuisance Washer Level warning lights does seem a common problem recently. It may be the float in the resevoir tank, but more likely to be a fault with the 'Red relay' under the dash, above UK drivers knees. I think the usual fix is to remove that relay since it is an expensive part to source. The circuit of the 'relay/timer' has been back engineered, so probably could be repaired or replicated.

Ref old posts:
https://forum.lotuselancentral.com/viewtopic.php?f=35&t=29069&hilit=washer+red

https://forum.lotuselancentral.com/viewtopic.php?f=35&t=29069&hilit=washer+red
S2 M100 NMY #285
N/A 2010 Evora
User avatar
KenS
Fanatic
 
Posts: 278
Joined: Mon 27.10.2014, 21:04
Location: North Kent Coast

Re: Washer tank empty indicator

Postby Tuga2112 » Mon 21.08.2023, 11:32

KenS wrote: The circuit of the 'relay/timer' has been back engineered, so probably could be repaired or replicated.


and theres another project for my todo list...
Still learning
Youtube Channel @Tuga2112 M100 repair videos
User avatar
Tuga2112
God
 
Posts: 3039
Joined: Fri 12.09.2014, 22:54
Location: Durham with a regular trip to Walsall

Re: Washer tank empty indicator

Postby timmo » Sat 26.08.2023, 10:55

Thanks everyone for your solutions. It's all fixed now and it was simply just a matter of unbolting the tank and unplugging electrical and pipe connections, giving the tank (which stank) a thoroughly good wash out with clean water. . Put it all back together and now problem is solved. I'm guessing it was a buildup of crap over the last 20 odd years gummed the sender up in the level sensor.
I wonder how much deeper the ocean would be without sponges.
User avatar
timmo
God
 
Posts: 1109
Joined: Sat 21.02.2004, 09:57
Location: Windsor


Return to Miscellaneous Problems - Need Help!

Who is online

Users browsing this forum: No registered users and 2 guests