Door Seals?

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Door Seals?

Postby Baz » Sun 12.08.2007, 22:08

:!: Can anyone tell me when you replace the seals on the hood which folds i.e the 2nd seal in from the top pillar does it come with the metal strip which the 2 screws go through?
Baz
Newbie
 
Posts: 38
Joined: Mon 28.05.2007, 18:06
Location: Dumbarton

Postby router » Mon 13.08.2007, 08:37

When you buy the hood seals thats all you get is the foam/rubber part

Sounds like you mean the intermediate seal
Last edited by router on Mon 13.08.2007, 11:00, edited 1 time in total.
User avatar
router
Enthusiast
 
Posts: 187
Joined: Fri 01.06.2007, 11:28
Location: Sheffield

Postby Gordon » Mon 13.08.2007, 10:15

yep, you only get the foam-rubber bits - clean up the old carrier, rust treat it, paint it, then glue the new seal on with Sikaflex.

Section BK (Addenda) Page 65 of the Service Manual is quite helpful.

The manual specifies Betaseal, but I had some Sikaflex handy and it did the job well...
1990 M100, Calypso Red
1981 S3 NA Esprit, Calypso Red
2005 Vectra C....
User avatar
Gordon
Fanatic
 
Posts: 474
Joined: Sun 09.07.2006, 18:31
Location: Torquay, Devon, UK

Postby Baz » Mon 13.08.2007, 14:02

:wink: Thanks Guys Didn't Know if It Was All Together Or Sperate!
Seen them on Ebay £107 for a pair i.e L+R Dont know if this was cheap or Not?
Baz
Newbie
 
Posts: 38
Joined: Mon 28.05.2007, 18:06
Location: Dumbarton

Postby Baz » Mon 13.08.2007, 14:02

:wink: Thanks Guys Didn't Know if It Was All Together Or Sperate!
Seen them on Ebay £107 for a pair i.e L+R Dont know if this was cheap or Not?
Baz
Newbie
 
Posts: 38
Joined: Mon 28.05.2007, 18:06
Location: Dumbarton

Postby Baz » Mon 13.08.2007, 14:03

Sorry sent the message a few times
Baz
Newbie
 
Posts: 38
Joined: Mon 28.05.2007, 18:06
Location: Dumbarton

Postby Gordon » Mon 13.08.2007, 14:16

1990 M100, Calypso Red
1981 S3 NA Esprit, Calypso Red
2005 Vectra C....
User avatar
Gordon
Fanatic
 
Posts: 474
Joined: Sun 09.07.2006, 18:31
Location: Torquay, Devon, UK

Postby RichardK » Mon 13.08.2007, 14:16

Baz,

Strongly recommend you visit the Lotus surplus parts webstore. The intermediate seals are on there for 11 quid a side plus P+P....well they were a couple of weeks ago when I bought myself two sets.

Richard

(edit....Gordon you beat me to it!)
User avatar
RichardK
Fanatic
 
Posts: 375
Joined: Sat 07.07.2007, 12:25
Location: New Orleans & Capetown

Postby Gordon » Mon 13.08.2007, 14:18

Pipped you by seconds there Richard... ;)
1990 M100, Calypso Red
1981 S3 NA Esprit, Calypso Red
2005 Vectra C....
User avatar
Gordon
Fanatic
 
Posts: 474
Joined: Sun 09.07.2006, 18:31
Location: Torquay, Devon, UK

Postby wayne » Sun 20.01.2008, 19:35

Hi

I havn't visited this forum for some time as I left bahrain just over a year ago and unfortunatly had to sell my elan.

Anyway I found this link whilst looking for seals for my new car and thought of you guys on here. They may not be able to supply the famous A post seals but they have a selection of other lotus seals that may be of some use to you

http://www.wefcorubber.com/PDF/automotive/LOTUS.pdf

reguards

wayne
User avatar
wayne
God
 
Posts: 885
Joined: Fri 12.09.2003, 00:38
Location: Bahrain

Postby dermotbell » Sun 20.01.2008, 19:43

Ah, Bahrain, many happy times there, even including meeting the wife there. :)
Dermot Bell
User avatar
dermotbell
Fanatic
 
Posts: 487
Joined: Sun 11.06.2006, 21:04
Location: Dubai


Return to Hood/Top, Bodywork and Fittings

Who is online

Users browsing this forum: No registered users and 6 guests