Water contamination

Post cries for help here if your topic fits no other thread in this category.

Moderators: theelanman, dapinky, Specky, clemo, Nige, Sy V, Dave Eds, DaveT, Elanlover, muley, Enright, algirdas, nitroman, GeoffSmith

Re: Water contamination

Postby paza1 » Tue 09.09.2008, 22:13

Neil,
Yea, I think you are correct. There is a return pipe to the filler neck but I can't see that it is enough for expansion.
Cheers
Mark
Silver 1992 SE Turbo.
paza1
Fanatic
 
Posts: 687
Joined: Thu 09.06.2005, 22:46
Location: Chester

Re: Water contamination

Postby dapinky » Tue 09.09.2008, 22:42

Galsia wrote:Kinda related question here. What is the best way to unblock the drain pipe near the fuel filler cap? Mine is blocked and I keep finding water in there am worried about water getting into the fuel system. I've got a bit of sponge in at the moment.

Thanks.



I use a piece of 0.8mm MIG welding wire - it will push down the pipe and is rigid enough to go round the kink without causing any problems.

I got so fed up with the pipe clogging up that i keep a length of welding wire wrapped round the filler neck and feeding down the drain pipe.

There is enough clearance to allow water to drain away, but if it gets clogged with leaf debris (we live on a hill, opposite a park) a quick wiggle soon empties out the water.
Dave

Just the one now, but this one's mine! - and it will be finished eventually..... - but also temporary custodian of a project until it is finished enough for Angie to drive it


...oh, and a 2006 Freelander destined for the jungles of The Gambia - 4500 miles across roads, desert and tracks - what could possibly go wrong?
User avatar
dapinky
LEC Administrator
 
Posts: 10605
Joined: Sun 15.10.2006, 12:54
Location: As far west as you can get in West Wales before you become Irish (Pembroke Dock).

Re: Water contamination

Postby Galsia » Thu 11.09.2008, 13:53

.
Last edited by Galsia on Thu 06.05.2010, 16:29, edited 1 time in total.
User avatar
Galsia
Enthusiast
 
Posts: 213
Joined: Thu 08.11.2007, 08:06
Location: Derby

Re: Water contamination

Postby Specky » Thu 11.09.2008, 19:41

Try pushing up if it won't go down...

TTFN
If you have a problem, if no one else can help, and if you can find them, maybe you can hire... The N/A-Team.
User avatar
Specky
Moderator
 
Posts: 5982
Joined: Sun 07.09.2003, 23:19
Location: Swindon

Re: Water contamination

Postby Ade » Thu 11.09.2008, 22:25

Hi all,
On clearing the pipe to drain away water. Mine as blocked a few times and an air hose as cleared it every time.

Ade
Ade
Fanatic
 
Posts: 311
Joined: Tue 22.04.2003, 19:40
Location: Broseley,Shropshire

Re: Water contamination

Postby Jackonicko » Wed 28.01.2009, 18:37

Where do you push up FROM, exactly?
Jackonicko
 

Re: Water contamination

Postby esprit888 » Wed 28.01.2009, 18:51

RayD wrote:Galsia,

I had trouble getting the wire round the bend, having said that mine wasn't blocked, but you can do it.

Test with water or WD40 to see if there’s a way through.

Try a small screwdriver in the hole without doing any damage, it should go down about 1½” to the bend. You may need to clean it out from the top.

Try pushing the wire up the pipe.

When it comes to getting the wire in from the top it needs to have a bend in it about a ¼” from the end and the bend needs to be pointing in the right direction...a bit of trial and error but generally away from you and to the left as you are stand at the side of the car...have another go.


Ray



Mine was plugged solid, i simply connected an air nozzle to the local garages air line (when they were not looking :-D ) and blew it out. It went with a 'POP' and a plug of crap splattered on the floor just in front of the rear wheel. Flushed it with soapy water and no problems since :D
User avatar
esprit888
God
 
Posts: 957
Joined: Fri 31.10.2008, 18:56
Location: Lotus Land-Canada

Re: Water contamination

Postby Paul.P » Wed 28.01.2009, 19:11

Galsia wrote:Kinda related question here. What is the best way to unblock the drain pipe near the fuel filler cap? Mine is blocked and I keep finding water in there am worried about water getting into the fuel system. I've got a bit of sponge in at the moment.


Galsia, try getting one of them plastic straws, it should fit the hole pretty tight, then blow down the straw, it cleared mine straight away, then you can just keep a spare straw in the glove compartment. Try McDonalds, they have loads !
JPS M100 was built from bare chassis up to create one off M100 in the mould of JPS Team Lotus
Paul.P
God
 
Posts: 4970
Joined: Sun 14.12.2003, 18:18
Location: Oakham, Rutland

Re: Water contamination

Postby dedmans » Wed 28.01.2009, 19:33

as posted once before use water absorbant in the tank. Overnight it will all go.
I could only clear my drain pipe with a length of 5mm electric wire, stuck it in and gave it a hard up and down plunge. other methods did not work for me.
All black S2
dedmans
Tinkerer
 
Posts: 68
Joined: Mon 18.06.2007, 21:34
Location: hampshire england

Re: Water contamination

Postby RayD » Sat 13.10.2012, 21:53

User avatar
RayD
Forum Member
 
Posts: 2142
Joined: Mon 20.03.2006, 19:45
Location: South Yorkshire

Re: Water contamination

Postby dedmans » Sat 13.10.2012, 22:45

Air compressor with the right adapter was the final method that I used. Had to do it regularly. No longer a problem to me as sadly the car has gone. Miss it but really like like the Z3 that we have now.
All black S2
dedmans
Tinkerer
 
Posts: 68
Joined: Mon 18.06.2007, 21:34
Location: hampshire england

Previous

Return to Miscellaneous Problems - Need Help!

Who is online

Users browsing this forum: No registered users and 3 guests