A Pillar Trim Screwa

[racerstev]

I need a little help. All 4 of my A pillar screws were seized in place and needed to
be driller out to remove the trim. Can someone tell me what size the srews are
supposed to be? Are they a machine screw or a self tapping? What diameter and
how long are they?

To be clear these go into the alloy windshild pillars at the top (2 per side).

Thanks for the help!
Steve

[epipete]

2nd attempt!

The manual states:

Screw, No 6 x1/2inch (A075W5020F (lol))

How did you drill out the old screws, what did you use - drill or grinder? I have the same issue and currently fixed the trim back with Number plate pads cut to size.

Pete

[racerstev]

I used a drill to take the head off and a grinder to flatten out what
was left over. I tryed to drill them all the way out but had no luck with it.

Ok, 1/2" long #6. I wonder if it's a 4mm X .7 like the mirror screws or just a
self tapping #6...

Steve